Our Air Conditioning model offers the Distribution Manager INTELLIGENCE and comes with two prewired vacant 240-volt output female plugs located on either side of the distribution manager. You can use your existing 20 - 30 or 40 amp Dryer - Range - Welder - outside RV Plug or any live 240 volt input line and directly use this as the input for the Distribution manager.
This line will become the priority appliance. You can then plug your 15, 20, 30, or 40 amp Air conditioner line into your disconnect then directly into the other available 240 volt female output plug located on the distribution manager.
The concept is to share the designated 30 or 40 amp breaker already installed in your panel and allocated to a output source somewhere in the house or shop. You can plug any 240 volt appliance up to 40 amps @ 240 volts in and the LOAD SHARING will begin between the Air Conditioner and the new appliance.
No need to HIRE AN ELECTRICIAN. All you have to do is attach the product on the wall with 4 screws (provided) plug the power cord (dryer or nema 50 plug provided on cord) from the Distribution Manager directly into the outlet already installed in your house. Run a wire or cord from your selected appliance and plug it directly into the box Its wired and ready to go in less than 20 minutes.
CONTRACTORS This saves the cost of HIRING AN ELECTRICIAN waiting for THEM TO SHOW UP and relying on other contractors to run the service for you, plus you won’t lose sales as you can install same day and save the cost ! PLUG AND PLAY